You have unread private messages

Club Logo Club Logo

310mm rotors

Thumbs Up
0

Created by Niall on 26 Aug 2014 22:46

Niall on 26 Aug 2014 22:46

Where does everyone buy theirs? Think im going to need a new set soon. I know Hispec sell them but anywhere else?

Niall

Not-so Noob (24)

Surrey

Owain on 26 Aug 2014 22:47

When Ash made the kits he designed it specifically with HiSpec for those rotors, wasn't even aware there was an alternative. 

Owain

Forum Nob (2868)

Chelmsford

Avatar
Niall on 26 Aug 2014 22:47

Ah i didnt realise that. In which case, ill get some from them then! Cheers

Niall

Not-so Noob (24)

Surrey

Niall on 26 Aug 2014 22:50

Seeing as Edit doesnt work properly.... ;)


Edit: Does anyone know the PCD of the top of their head? 180 or 190?

Niall

Not-so Noob (24)

Surrey

Owain on 26 Aug 2014 22:53

Yeah, yeah, yeah, just busy deciding which one of you I'm going to murder first. 

The top of my head has a PCD of 8 x 50mm.

Owain

Forum Nob (2868)

Chelmsford

Avatar
devere on 27 Aug 2014 21:01

I hope you have a better time with hi spec than I have. I've been waiting 8 weeks for my bits so far! Every time I try and chase them up I get fobbed off. Then they say they will call back and never do.

Massive bunch of wasters is my experience.  After ringing about 4 times today, the parts are APPARENTLY being sent out tomorrow.

Anyway, rant over.  Good luck getting your discs!

devere

Not-so Noob (45)

Avatar
Niall on 27 Aug 2014 22:48

Ive dealt with them before (had hispec 4 pots before these) and they were ok but all i was buying was a partial rebuild kit. I went in there as they arent far from me and the guy at the counter was very helpful but i was shocked at the size of their setup. The whole lot was based in a building about twice the size of a normal double garage!

Niall

Not-so Noob (24)

Surrey

devere on 27 Aug 2014 23:12

Sounds like a circus sketch of how many clowns can you fit in a car then.

Although I'd have had happier and easier dealings from real clowns...

devere

Not-so Noob (45)

Avatar
aaron6 on 30 Aug 2014 08:39

You don't need much room for a CNC lathe and machining center.

aaron6

Not-so Noob (44)

Maidstone

1 - 1 + 1

Are you sure you wish to lock this discussion?

Are you sure you wish to unlock this discussion?

Edit dat?

Deleting your post eh? Drunk were we?

Are you sure you wish to delete this entire discussion?

0 online users
The views and opinions expressed on this site are those of the authors and do not necessarily reflect the views of the club, its creators, moderators or other members.

Club Logo

© Gti7.Club 2020